The Wear Measurement module is designed to measure the amount and direction of wear to an implant.

Looking for biometric analysis? mediCAD has what you need!

This module contains the tools you need to automatically determine values and measurements on ML or AP imagery.

The analysis produces the type, quantity, size, and localization of the osteotomies. Following the correction, all joint-based mechanical load axes and joint tangents must be within the normal range.

With the Osteotomy module you can plan femoral or tibial corrective osteotomies with single or multiple osteotomies, with open wedge or closed wedge techniques.

Bone segments may be exempted and shifted and required osteosynthesis products may be put into position.

The knee endoprosthetic module is used to plan knee prosthetics. Any defective axis positions can be detected and corrected during planning.

The Endoprosthetic module supports the planning of hip implants.

In 1994, HECTEC GmbH began developing a solution that gives orthopedic surgeons digital tools for efficient and safe planning of joint operations.